Access Point Mode Configuration; Access Point Mode Introduction; Zyxel Utility Screen Summary; Additional Setup Requirements - ZyXEL Communications ZyXEL ZyAIR G-120 User Manual

This chapter shows you how to configure your G-120 in access point mode.

5.1 Access Point Mode Introduction

To use your G-120 as an Access Point (AP), select AP Mode in any utility screen (refer to
Section 1.2.3 on page
In access point mode, your G-120 allows you to set up your wireless networks without using a
dedicated AP.

5.1.1 ZyXEL Utility Screen Summary

This section describes the ZyXEL utility screens when the G-120 is in AP mode.

Figure 38 ZyXEL Utility Menu Summary: AP Mode

The following table describes the menus.

Table 15 ZyXEL Utility Menu Summary: AP Mode

TAB
AP Mode
Link Info
Configuration
MAC Filter

5.1.2 Additional Setup Requirements

To bridge your wired and wireless networks using the G-120, the following requirements must
be met:
1 The G-120 must be installed on a computer connected to the wired network.
2 Either configure network sharing (refer to
bridge the two interfaces (wireless and wired) on the computer.
Chapter 5 Access Point Mode Configuration
Access Point Mode
23).
DESCRIPTION
Use this screen to see your current connection status, configuration and data rate
statistics.
Use this screen to configure wireless LAN settings.
Use this screen to configure which computer(s) you want to access the wireless
LAN through the G-120.
ZyXEL G-120 User's Guide
C
H A P T E R
Configuration
Appendix B on page 75
5
for an example) or
61