Table of Contents
Advertisement
Omni 56K II and Omni 56K Plus II User's Guide
RESPONSE
+FTSI:"string"
+FVOICE
Class 2 Flow Control
Flow control is necessary to match the DTE-DCE data rate to the line-signaling rate while transmitting or
receiving Group 3 (T.4) data. In Class 2 fax mode, both hardware (RTS/CTS) and software (XON/XOFF)
flow control are enabled.
5.2.3
Service Class 2.0 Commands
COMMAND
+FDT
+FDR
+FKS
+FIP
+FCLASS=n
+FMI?
+FMM?
+FMR?
+FCC=vr,br,wd,In,df,ec,bf,st
5-18
VALUE
command.
Report the remote ID response TSI.
Changes to voice response.
Table 5-11 Service Class 2.0 Commands
DESCRIPTION
Transmit a phase C data command.
This command releases the DCE to
proceed with the negotiation.
Receive a phase C data command.
This command initiates document
reception.
Terminates a Session, orderly fax
abort.
Initialize the Service Class 2.0
Parameters.
Service Class Identification and Control
Identify DCE Manufacturer
Identify DCE
Identify DCE Revision
Establish DCE Capabilities
Vertical Resolution
FUNCTION AND DESCRIPTION
n=0,1,2.0,8;refer to the
+FCLASS Class 1 command
ZyXEL
Omni 56K II/Omni 56K Plus II
Vx.x
vr=0:Normal;98 lpi
vr=1:Fine;196 lpi
VALUE
Command Sets
Advertisement
Table of Contents
