Table 5-10 Class 2 Command Responses - ZyXEL Communications Omni 56K II User Manual

All other +F commands are not supported, but the modem will respond OK. In many cases this means "don't
care."
RESPONSE
+FCFR
+FCIG:"string"
+FCON
+FCSI:"string"
+FDCS:vr,br,wd,ln,df,
ec,bf,st
+FDIS:vr,br,wd,ln,df,
ec,bf,st
+FDTC:vr,br,wd,ln,df,
ec,bf,st
+FET:n
+FHNG:n
+FNSC:"HEX string"
+FNSF:"HEX string"
+FNSS:"HEX string"
+FPOLL
+FPTS:n
Command Sets
Table 5-10
Class 2 Command Responses
VALUE
Confirmation.
Reports the remote ID response CIG.
Facsimile connection response.
Reports the remote ID response CSI.
Reports the session parameters response; refer to the +FDCC=....
command.
Reports the session negotiation parameters response; refer to the
+FDCC=.... command.
Reports the remote capabilities response; refer to the +FDCC=....
command.
Message response for a received page; refer to the +FET=n command
in Table 5-9.
Call termination status response.
n=00 Normal and proper end of connection.
n=10 Transmit error on phase A hang up code.
n=20 Transmit error on phase B hang up code.
n=40 Transmit error on phase C hang up code.
n=50 Transmit error on phase D hang up code.
n=70 Receive error on phase B hang up code.
n=90 Receive error on phase C hang up code.
n=100 Receive error on phase D hang up code.
Reports the non-standard facilities command frame.
Reports the non-standard facilities frame response.
Reports the non-standard setup frame response.
Remote polling indication.
Receive a page transfer status response; refer to the +FPTS=n
d
Omni 56K II and Omni 56K Plus II User's Guide
FUNCTION AND DESCRIPTION
5-17