ZyXEL Communications Omni 56K II User Manual page 76

Omni 56K II and Omni 56K Plus II User's Guide
COMMAND BIT
6
7
S24= bit
6-4
S25=
S26=
S27= bit
0-2
3-5
5-30
DEC HEX
32 20 ATX4
40 28 ATX5, error control result code is enabled (default).
48 30 ATX6, error control result code is enabled.
56 38 ATX7, error control result code is enabled.
0 0 Displays the result code in numeric format (see
S35.7).
64 40 Displays the result code in verbose format (default).
0 0 The modem returns the result code (default).
128 80 The modem does not return the result code (see also
S40.1).
dec hex Bit-mapped register.
16- 10-70 Speaker volume control, increments of 16 in decimal
112 value.
0 to 0-FF Specify the time delay that the DTR signal needs to be
255 OFF before it is recognized, in 10 ms units. If S25=0,
the delay time is set to 4 ms.
dec hex RTS/CTS delay.
0 to 0-FF Set the delay, in 10 millisecond units between the RTS
255 and the modem's CTS response in synchronous mode
(see '&Rn' command).
dec hex Bit-mapped register.
Modem error control.
0 0 No error control.
1 1 MNP4 + MNP3 (see also S41.0).
2 2 MNP4 + MNP5 (see also S38.5, S41.0).
3 3 V.42+MNP4
4 4 V.42 + V.42bis (compatible with &K2) (default).
0 0 Flow control disabled
24 18 Hardware (RTS/CTS) flow control (default)
32 20 Software (RTS/CTS) flow control
FUNCTION AND DESCRIPTION REF.
X4
X5
X6
X7
V0
V1
Q0
Q1
L0-3
+000
+000
&Rn
+156
&K0
&K1
&K2
&K3
&K4*
Command Sets