ZyXEL Communications Omni 56K II User Manual page 80

Omni 56K II and Omni 56K Plus II User's Guide
COMMAND BIT
S48= bit
0
2
3
4
S52= bit
7
S56= bit
S57= bit
4
Bit S-register bit number, 'b', used in 'ATSr.b=n' and 'ATSr.b=?'
Dec Decimal value, 'x', used in 'ATSn=x'
Hex Equivalent Hexadecimal value.
+nnn Factory default when listed in 'Reference' column.
AT' is omitted when an AT command is referred to in the 'Reference' column.
Note:
5-34
DEC HEX
0 to 0-FF To process the CND, silence must be detected for the
255 specified interval, in 20 ms units.
dec hex Bit-mapped register.
1 1 This causes CND information to be reported in raw
format.
4 4 This enables the sending of data calling tones (CNG).
8 8 Reverses the V.23 channel speed. Originate mode
modem speed (Send/Receive) 1200/75; Answer mode
modem speed (Send/Receive) 75/1200.
16 10 (Works with the &D1 command) DTR ON causes the
modem to dial the default number and DTR OFF
causes the modem to hang-up and reset to profile 0.
When the modem is idle (waiting for a command), it
does not dial any number when DTR changes from
ON to OFF.
Dec hex Bit-mapped register.
0 0 Select 'Mark' as the first signal of the V.23
handshaking sequence (default).
128 80 Select 'Space' as the first signal of the V.23
handshaking sequence (default).
dec hex
0 to 0-FF Hook flash detect time, in units of 10ms. A value of
255 zero uses country-specific default duration.
dec hex Bit-mapped register.
16 10 Enables the reporting of Class 1 capability in response
to +FCLASS=?
FUNCTION AND DESCRIPTION REF.
+000
&N12
+000
&N12
&N12
+000
+016
Command Sets