Table of Contents
Advertisement
Omni 56K II and Omni 56K Plus II User's Guide
COMMAND
+FNR=rpr,tpr,idr,nsr
+FIE=n
+FPS=n
+FLO=n
+FPR=n
+FBO=n
+FEA=n
5-20
DESCRIPTION
Enable Negotiation Reporting
Procedure Interrupt parameter
Page Transfer Status
Flow Control Select
Serial Port Rate Control
Phase C Data Bit Order
Phase C Received EOL alignment
VALUE
rpr= 0:Receiver parameters are
not reported.
rpr=1:Receiver parameters are
reported.
tpr= 0:Transmitter parameters
are not reported.
tpr=1:Transmitter parameters
are reported.
idr= 0: ID Strings are not
reported.
idr=1: ID Strings are reported.
nsr= 0:Non-standard frames
are not reported.
nsr= 1:Non-standard frames
are reported.
n=0:Disable
n=1:Enable
n=1:Received page is good.
n=2:Page is bad; retrain is
requested.
n=3:Page is good; retrain is
requested.
n=4:Page is bad; procedure
interrupt is requested.
n=5:Page is good; procedure
interrupt is requested.
n=0:No flow control
n=1:Sets XON/ XOFF software
flow control
n=2:Sets CTS/RTS hardware
flow control
n=0:Automatic DTE rate
detection by the DCE
n>0:Serial rate is fixed at the
value multiplied by 2400 bps.
n=0:Selects direct bit order
n=1:Selects reversed bit order
n=0:EOL patterns are as
received
Command Sets
Advertisement
Table of Contents
