Table 19. Class 2 Command Responses - ZyXEL Communications Omni 56K User Manual

User's Guide for ZyXEL Omni 56K USB Modem
COMMAND
+FMINSP=n Minimum phase C speed parameter:
2400 bps.
4800 bps.
7200 bps.
9600 bps.
12000 bps.
14400 bps.
+FPHCTO= DTE Phase C response time-out:
<value> Determine how long the DCE waits for a command after reaching
the end of data when transmitting in Phase C.
<value>=0 to 255; 100 ms units.
+FPTS=n Page transfer status:
Received page good.
Page bad; retrain requested.
Page good; retrain requested.
Page bad; procedure interrupt requested.
Page good; procedure interrupt requested.
+FREL=n Phase C received EOL alignment:
The EOL patterns are bit aligned as received.
The last received bits of EOL patterns are byte aligned by the
DCE, with necessary zero fill bits inserted. Refer to TIA
(Telecommunications Industry Association) PN-2388 for details.
+FREV? Request the DCE revision identification.
+FSPL=n "Enable polling" command:
Disable polling.
Enable polling.
All other +F commands are not supported, but the modem responds OK. In many cases
this means "it is ignored".
RESPONSE
+FCFR
+FCIG:"string"
+FCON
+FCSI:"string"
+FDCS:vr, br, wd, ln,
df, ec, bf, st
+FDIS:vr, br, wd, ln,
df, ec, bf, st
+FDTC:vr, br, wd, ln,
df, ec, bf, st
+FET:n
+FHNG:n
5-14
DESCRIPTION
Table 19. Class 2 Command Responses
VALUE FUNCTION AND DESCRIPTION
Confirmation.
Report remote ID response CIG.
Facsimile connection response.
Report remote ID response CSI.
Report session parameters response; refer to
+FDCC=.... command.
Report session negotiation parameters
response; refer to +FDCC=.... command.
Report remote capabilities response; refer to
+FDCC=.... command.
Post page message response; refer to the
+FET=n command.
Call termination status response:
VALUE
n=0
n=1
n=2
n=3
n=4
n=5
0 to 255
n=1
n=2
n=3
n=4
n=5
n=0
n=1
n=0
n=1