Avaya DECT Installation Manual page 7

Link Kit
20DT Handset
Single Chargers
Multi Charger
Accessories
DECT - Installation Manual
38HBKD0001SAH – Issue 14 (27th October 2003)
Use of a pair of Link Cards and a Link Cable allows two DCU's to operate
as a single system (see Linked DECT Systems on page 60).
Each handset is supplied with a User Guide and battery.
Weight: 121g ±10g including battery.
–
– Size: 143mm x 48mm x 26mm.
– Power: Fully charged battery; 10 hours speech, 90 hours standby.
Full battery recharge, 3.5 hours in handset charging slot.
Note: A label, located beneath the battery pack, provides both the
handset registration number and the software level.
The single chargers are designed as a free-standing desk units. There are
two designs of single charger. One has slots for charging the battery whilst
in the handset (normal charge). The other has an additional battery only
charging slot (quick charge).
The single chargers are supplied with a mains power supply unit
appropriate to the ordering country.
– Size: 65mm wide x 60mm high x 95mm deep.
– Power Supply: Single 220V 50Hz mains power supply.
The multi-charger supports normal charging of up to 4 handsets (DH1/2
handsets only). Each slots has its own charging and charged LED's. The
unit can be used either as a free standing desk unit or wall mounted.
The unit is supplied with a mains power supply unit appropriate for the
ordering country.
Other accessories such as vibrating clips and headset adapters are
available.
Introduction - Page 7
Page 7
The DECT System