Avaya DECT Installation Manual page 52

Page 52 - IP Office Integration
User Configuration
DECT Handset as a Slave of a Desktop Phone
Page 52
DECT Configuration Software
Each user assigned to a DECT handset must be configured and the
Internal directory set up. Perform the following:
1. From Programs/IP Office, open the Manager application. The default
password for Administrator is Administrator, however this must be
changed as early as possible.
2. Open the Configuration Tree (File/Open). The default password for the
configuration is password, however this must changed as early as
possible.
3. In the Configuration Tree, open User to display all available Users.
4. For each analogue port assigned to a DECT handset, right click in the
User icon and select Edit.
5. In the User tab enter both a Name and Full Name. These names
should be unique to each DECT handset and will represent the
Internal directory.
6. Select the Voicemail tab and ensure that:
- When voicemail for the DECT is required that the Voicemail On box
is ticked
- Where voicemail for the DECT or the DECT is to be slave of a
desktop
phone (see page 52), that the Voicemail On box is empty.
A DECT handset can be made a slave of an IP Office desktop handset.
Perform the following:
1. From Start | Programs | IP Office select DECT Configuration (the
CCFP application must not be runniing).
2. You will be given the option to switch off the DECT service. Select
Yes.
3. The IP Office DECT Configuration menu is displayed.
The password must be that of the IP Office connected to the DECT.
4. Check that either the Host Name or IP Address is displayed. If not,
enter the IP address of the IP Office.
Enter either the name of
the host IP Office or it's
IP Address
Enter the password of the host
IP Office
Click here to access the
Extension Dialog menu (see
below). When completed,
the number of DECT
handsets available to be
twinned is displayed
Tick this box to gain access to
the Connect and configure
menu and hence enable
twinning (see below).
The number of the DECT
handset (identified above) and
the number of the desktop
phone will appear here (e.g.
201 – 203) after Connect and
configure menu has been
completed (see below).
DECT - Installation Manual
38HBKD0001SAH – Issue 14 (27th October 2003)