Avaya DECT Installation Manual page 59

Configuring a Repeater
DECT - Installation Manual
38HBKD0001SAH – Issue 14 (27th October 2003)
1. Locate and click on the Kirktool icon.
Windows 3.x:
Windows 95/NT:
2. Click on Communication and set this to the Comport Setting (serial
port) connected to the Repeater.
3. Click on Repeater and click on Read from Repeater to load the
connected Repeater's current settings. These may be empty.
– CCFP: This is the number of the DCU. The number of the DCU
can be found from the CCFP application (see PC/CCFP Version.
on page 38) Also ensure that the Allow Subscription is set to yes
(see Subscribing Handsets on page 26).
– Base to synchronize on: The base station number of the DBS
with which the Repeater should synchronize.
– Repeater number: The base station number for the Repeater.
4. Click on New and enter the required values
5. Click on Write to Repeater.
– Error messages appear if any values are not correctly set.
6. Click on Read from Repeater and check that the values are as
required.
7. Click on Exit. You can now use the Repeater.
Located in the desktop group Kirktool.
Located in Start | Programs | Kirktool.
Repeater Base Stations - Page 59
Page 59
The Repeater Setup Program