Linked Dect Systems; Introduction; Upgrading Existing Dect Systems - Avaya DECT Installation Manual

Page 60 - Linked DECT Systems

Linked DECT Systems

Introduction

Handsets
64 off max.
Base Station
(16 off max.)
Repeater
Slave Jack
Socket
IKm Single Twisted Pair Cable
To/From Base Stations 0 -7
To/From Base Stations 8 - 15
To/From Base Stations 16 - 23
To/From Base Stations 24 - 31

Upgrading Existing DECT Systems

Page 60
Introduction
The DECT Link Kit allows two DCU's to be connected. They then act as a
single DECT system with one DCU taking the role of master and the other
slave.
Communications
Platform
(PBX)
Twisted Pair
Analogue
Interface
Cables
DECT Intergration
Cable
Serial Programming Cable
To/From DECT Analogue Interface Channels 8-63
5m 12-Pair Cable to 25-Way Female D-Type for Channels 0 - 7
To/From DECT Analogue Interface Channels 72 - 127
5m 12-Pair Cable to 25-Way Female D-Type for Channels 64 - 71
MDF
5m 12-Pair Cable to 25-Way Male D-Type for Base Stations 0 -7
5m 12-Pair Cable to 25-Way Male D-Type for Base Stations 8 - 15
5m 12-Pair Cable to 25-Way Male D-Type for Base Stations 16 - 23
5m 12-Pair Cable to 25-Way Male D-Type for Base Stations 24 - 31
The Link Kit consists of:
– Link Cards:
These cards (one slave and one master) go into the left hand slots of
each DCU motherboard. They provide an external connector for the
DECT Link cable.
– Link Cable:
This cable connects between the two Link Cards. It is a 1m cable with
male connector and one end and female connector at the other.
– Replacement Eprom Chips:
If either cabinet contains an 13298200 chip, it must be replaced with
one of the 13298201 chips supplied in the Link Kit.
– Software Disk:
This disk includes version 5 SIO and associated files which are
required for Linked DECT systems. It also includes new versions of
F_APP_DB.DAT. It also includes a FLASH.KTB file for upgrading
linked cabinets.
Link Cards can only be used in DCU's with HW PCS6+, SW PCS5+. If
necessary the motherboard of any existing DCU must be upgraded to that
level (by either replacing the motherboard or the whole DCU).
The Link Kit includes replacement Eprom chip to be used if necessary
(see Eprom Replacement on page 63).
DECT Control Unit (Master)
DECT Expansion Board
DECT Analogue Interface Cables
(25-Way Female D-Types to MDF)
Either
1m Link Cable
PC
38HBKD0001SAH – Issue 14 (27th October 2003)
DECT Control Unit (Slave)
DECT Expansion Board
DECT Analogue Interface Cables
(25-Way Female D-Types to MDF)
DECT - Installation Manual