Zoom X5 User Manual page 31

Destination IP address of the subnet.
Netmask
Subnet mask address that corresponds to the
Destination's IP address.
Gateway
IP address of the Gateway that is on the same
subnet as the modem.
—Specify IP Choices are enter a static IP address or select an
interface type from a dropdown list.
—Select Interface
#
As you add entries to the Route Table, the X5
automatically assigns sequential ID numbers.
To manually configure entries for your X5's Route Table, follow
these steps.
1 1 1 1
Enter the subnet's IP address in the Destination field.
2 2 2 2
Enter the matching subnet mask address in the Netmask field.
3 3 3 3
Click the Specify IP button and enter the Gateway's IP
address. Tip: If you need help determining the Gateway's IP
address, from the Command prompt of the computer acting as
the Gateway, type ipconfig /all.
4 4 4 4
Select Add from the dropdown list and then click Save
Changes. (If you want to delete your entry and begin again,
click Reset.) When the Route Table page displays again, you
will see your new entry in the Manually Configured Routes
table at the bottom of the page, along with an ID number.
Should you ever want to remove an individual route table entry,
follow these steps.
1 1 1 1
In the Destination and Netmask fields, enter the IP address
information for the entry that you want to remove. (You do
not have to enter the Gateway IP address.)
2 2 2 2
Select Delete from the dropdown list and then click Save
Changes.
Chapter 2: Advanced Setup Options 31