Trouble Shooting Guide - Gastroback DESIGN EASY JUICER Instructions For Use Manual

Table of Contents

Advertisement

Available languages

Available languages

TROUBLE SHOOTING GUIDE

Possible Problem
Machine will not work when
switched ›ON‹
Motor appears to stall when
juicing
Excess pulp building up in
the micro mesh filter basket
Pulp too wet and reduced
extracted juice
Juice leaks between the rim
of the juicer and the cover
of the filter
Bowl surround juice sprays
out from spout
Juicer makes loud noise
when turned on
No juice coming out while
juicing
Easy Solution
The safety locking arm may not be correctly engaged in the vertical operating posi-
tion with the locking arm located into the two grooves on either side of the juicer
cover).
Wet pulp can build up under the cover if the juicing action
is too vigorous. Try slower juicing action by pushing the food pusher down more
slowly. Clean the integrated pulp container, the stainless steel filter basket and the
juicer cover.
Stop the juicing process. Remove the juicer cover, scrape off pulp. Re-assemble and
begin juicing again. Try alternating (soft and hard) vegetable and fruit varieties.
Try a slower juicing action by pushing the food pusher down more slowly. Remove
stainless steel filter basket and thoroughly clean mesh walls with the nylon brush.
Rinse the stainless steel filter basket under hot water. If the fine mesh holes are
blocked, soak the stainless steel filter basket in a solution of hot water with 10%
lemon juice to unblock the holes or wash in the dishwasher. This will remove excess
fibre build up (from fruit or vegetables) which could be inhibiting the juice flow.
Try a slower juicing action by pushing the food pusher down more slowly. Fruit and
vegetables with a high water content (tomatoes and watermelon) should be juiced
on low speed.
Try a slower juicing action by pushing the food pusher down more slowly.
Filer basket is not properly snapped into position. Turn the On/OFF button to OFF.
Turn the power OFF. Disassemble the Easy Juicer (refer to ›disassembling‹). Re-
assemble (refer to ›assembling‹).
Check that the spout is not blocked with pulp. Refer to ›Care and cleaning‹.
43

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

40118

Table of Contents