Setting Coverage Range Of The Colour Camera - Gira 2551 20 Installation And Operating Instructions Manual

Setting range of coverage of colour camera
12
1. Remove the colour camera from the back of the
front panel of the Door Station Stainless Steel:
Loosen both screws of the attachment profile for
this purpose.
2. Remove the camera cover plate from the demounted
colour camera.
3. Slightly loosen both Torx screws to the left and right
of the camera lens.
i
Do not take out the screws completely!
When adjusting the lens carrier, it is sufficient to
slightly loosen the screws. Do not take out the
screws completely from their brackets.
4. Set the camera lens in the desired direction.
5. For testing purposes, install the colour camera in the
front panel and check on the TFT display of the con-
nected home station whether the set angle of the
camera lens is adjusted properly, and whether the
view of the person in front of the door is optimal.
6. Remove the colour camera again and lock the lens
carrier by tightening both Torx screws.
7. Mount the camera cover plate.
8. Mount the camera into the front panel of the Door
Station Stainless Steel and fasten it.
Ensure proper seating of the black seal.