ABB SensyMaster FMT430 Operating Instructions Manual page 117

SensyMaster FMT430, FMT450 THERMAL MASS FLOWMETER | OI/FMT430/450-EN REV. B
Menu / parameter
Input/Output / ...Dig.Out V1/V2
Input/Output / ...Dig.Out V3/V4
Mode
...Binary Out V1/V2 / V3/V4
...Alarm Cfg. V1/V2 / V3/V4
Input/Output / ...Dig.Out V1/V2 / ...Binary Out V1/V2
Input/Output / ...Dig.Out V3/V4 / ...Binary Out V3/V4
Signal Source Binary
Active Mode
Input/Output / ...Dig.Out V1/V2 / ...Alarm Cfg. V1/V2
Input/Output / ...Dig.Out V3/V4 / ...Alarm Cfg. V3/V4
General Alarm
Qm Massflow Max
Qm Massflow Min
Qv@ Volumeflow Max
Qv@ Volumeflow Min
Tm Temperature Max
Tm Temperature Min
Sensor Soiling
Input/Output / ...Dig.In V1/V2
Input/Output / ...Dig.In V3/V4
Function
Active Mode
Delay Time
Description
Selection of operating mode for the digital output V1 / V2 or V3 / V4.
• Off: Digital output deactivated.
• Binary: Digital output functions as binary output (for function see parameter '„...Binary Out V1/V2 / V3/V4').
The digital outputs V1 / V2 and V3 / V4 are only available if the corresponding plug-in cards are present!
Selection of submenu '...Binary Out V1/V2 / V3/V4' using
Only available if 'Mode' Binary has been selected.
Selection of submenu '...Alarm Cfg. V1/V2 / V3/V4' using
Only available if 'Mode' Binary has been selected.
Selection of binary output function.
See description '„Input/Output / ...Dig.Out 41/42 / ...Binary Out 41/42'.
Select switching properties for the binary output.
• Active High: Normally open
• Active Low: Normally closed
Select error messages signaled via the binary output V1 / V2 or V3 / V4.
Only if the parameter "Signal Source Binary" has been set to "Alarm".
In preparation
Select a function for the digital input.
• Off: No function.
• Reset all Totalizer: Counter reset for all counters
• Stop all Totalizer: External counter stop for all counters
• Set Flowrate to zero: Sets flow measurement to 0. Heating of the thermal measuring element is also switched off here
• Start/Stop Batching: Start / stop fill operation (only when FillMass function is activated).
• Act. App.Selector1|3: Application selection via the digital input (with digital input V1 / V2 only).
• Act. App.Selector2|3: Application selection via the digital input (with digital input V3 / V4 only).
Select switching properties for the digital input.
• Active High: Normally open
• Active Low: Normally closed
Selection of delay time for suppressing EMC faults on the digital input.
.
.
117