Feed Top Rod Into Door; Align With Lockbody Cassette (Lbc) - Assa Abloy Sargent 7300 Series Installation Instructions Manual

7300 Series
Multi-Point Lock
Installation Instructions
5 Addendum (cont.)
e

Feed Top Rod into Door

• Orient the latch chassis as shown. Rotate the
rod and rod guide so the rod guide tab faces
up. Slide the rod assembly into the door. Make
sure the rod guide remains in the correct
orientation with the guide tab facing up.
(Figure 37)
f

Align with Lockbody Cassette (LBC)

• When approaching the LBC, slightly elevate the rod and slide the guide tab on outer diameter of the
LBC gear. (Figure 38)
• To align the hex of rod with the hex of the LBC gear, fit the rod guide tab into the LBC gear slot. Once
aligned, push the rod assembly in until fully seated. (Figure 39)
1-800-727-5477 • www.sargentlock.com
Copyright © 2017, 2019, 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or in
part without the express written permission of SARGENT Manufacturing Company is prohibited.
Figure 37
LBC
Gear
Figure 38
Figure 39
18
guide tab
Latch chassis holes
to mate with door
face holes.
Rod Guide
A8270A 02/20