Table of Contents
Advertisement
Turn the System Part 2 On (Cmd 3)
Exit Delay Time (to be filled in by your security company).
You have __________ sec. to exit premises before system turns on.
I can perform this command.
I cannot perform this command.
Part 2 On turns on the portion of your system designated as Part 2, leaving the rest of the system turned off. You can select
the points that turn on for Part 2 On, whereas Part On points are determined by your security company (see Set Part 2
Points on page 14). Once you press [CMD] [3], the exit delay timer countdown begins.
In the following example, 60 sec, is used as the Exit Delay. Exit Delay is set by your security company and may vary from the
example shown below.
1.
Make sure that points are normal (not faulted).
2.
Press [CMD] [3] to turn the system Part 2 On. The command center may prompt you to enter a valid
passcode.
3.
Enter your passcode if necessary. The On indicator turns on. The command center display scrolls the
following:
Enter your passcode to stop the system from turning on during the exit delay. You can turn the system Part 2
On with No Delay by pressing [NO DELAY], or you may bypass points by pressing the [BYPASS] key.
4.
During the last 10 sec. of Exit Delay, the command center displays Do not exit! and emits a double tone
every second to warn you not to exit and to turn the system off. The system turns Part 2 On. The On indicator
remains on steady.
5.
Enter your passcode to turn the system off.
© 2003 Bosch Security Systems
Smiths Residence
Ok for Part On
60 seconds to
Part 2 On.
To bypass points
Press Bypass.
For no delay
Press No Delay.
For All On
press All On
48 seconds to
Part 2 On.
Smiths Residence
Part 2 On
D623/D625 User Guide
Page 13
Security System
User Guide
46841D
Advertisement
Table of Contents
