Table of Contents
Advertisement
Security System
User Guide
Change Passcode (Cmd 55)
I can perform this command.
I cannot perform this command.
Use this command to change your passcode at any time. However, only use this feature under the direction of your
security company. The system must be off in order to use this command.
Write down your new and old passcode before you begin.
1.
Make sure your system is off (On indicator is off).
2.
Press [CMD] [5] [5]. The OK tone sounds and the command center displays:
3.
Enter your current passcode. As you enter your passcode, the command center displays:
4.
If the passcode you have entered is valid, you are prompted to enter your new passcode:
5.
Enter a new passcode with the same number of digits as your old passcode. If the error tone sounds, try a
different new passcode. As you enter your new passcode, the command center displays:
6.
If you have entered a valid new passcode, the command center prompts you to enter the new passcode again:
7.
Enter your new passcode again. As you enter your new passcode, the command center displays:
8.
The command center displays the following to confirm you have successfully changed your passcode:
The command center returns to the normal display.
46841D
Please enter
old code
Entering Code
***
Please enter
new code
Entering Code
***
Please enter
new code again
Entering Code
***
Code changed
D623/D625 User Guide
Page 20
© 2003 Bosch Security Systems
Advertisement
Table of Contents
