Advantech ADAM-3600-C2G Series User Manual page 46

fd ed =>fd
When the send data is as follows: 01 0a fd cd fe fe 22, the escaped data is as follows: 01 0a
fd ed cd fd ee fd ee 22.

Webaccess WhereIAm Protocol
Figure 4.26 Webaccess WhereIAm Protocol in active connection
The additional Identifier Device parameter is required in Webaccess WhereIAm protocol. The
identifier device number must correspond with the upper Webaccess and the length of the
string is 1~60.
4.2.6 System Settings
The system setting of iRTU Studio includes two parts: I/O setting and network setting.
4.2.6.1 I/0 Settings
The ADAM-3600-C2G is equipped with 8 AI channels, 8 DI channels, and 4 DO channels.
Besides, there are four I/O expansion slots which can integrate various I/O modules into the
main unit. In the Studio, for both on-board I/O and expansion I/O, user can set mode, I/O
range, integration time as well as calibration.
Configure the I/O setting as below figures to provide an initiated setting to the on-board I/O
and expansion I/O
(1) AI supports 4 IO ranges: ±10V,±2.5V?0~20mA,4~20 mA
(2) DI supports 2 modes: Normal & Counter
(3) DO supports 2 modes: Normal & PWM
The figure below shows the configuration page the ADAM-3600-C2G on-board IO; AI,DI,DO
in the same page:
ADAM-3600 Series User Manual 38