4. Data writing for Serial number and Model number
• When all data cannot be copied
• After the replacement of PCB Main Ass'y
1. Data writing for each model is carried out
2. PCB Main Ass'y adjustments (Flicker adjustments, Usage Time setup)
3. EDID data writing is carried out
4. Data writing for Serial number and Model number
Model-Specific Data Writing Procedure
Model-specific data writing procedure
Writing procudures shall be performed from step 1 to step 2.
1.
Writing the model-specific VerUpField data
Writing software : PJUpgrader2vupf.exe
File name to be written : ********_vupf_V000001.bin
2.
Writing the model-specific product data
Writing software : PJUpgrader2.exe
File name to be written : *********_Data_V102025.bin
3.
Initial setting of writing software
[COM port]: Set the COM port of the used PC (this is explained in the following procedure).
[Baud rate]: Match the setting of the PJ
Operation Procedure
Prior to operation, install the writing software (PJUpgrader2vupf.exe and PJUpgrader2.exe) and copy
the files for the model (********_vupf_V000001.bin and ********_Data_V102025.bin).
Model-specific VerUpField data
1.
Connect the projector to a PC with a PC control cable.
2.
Turn the power ON, pressing the [ENTER] and [BACK] keys of the main unit
simultaneously. (AC source turned on)
Electrical Adjustment
75