Table of Contents
Advertisement
8.2.4.2. Luminaires (ELC)
On the luminaires screen, a summary will appear at the top of the luminaires registered
and with a fault on the device.
At the bottom, view the status and configure each of the luminaires registered. The
display is made by circuit; i.e., first select a circuit and then go to all luminaires
connected to this circuit.
Overview
Installed:
In failure:
In brackets, indicate which of these luminaires are failing due to lack of communication.
Filter:
allows to filter the luminaires:
Circuit:
displayed
Serial number:
Status:
•
Communication loss:
than 24h.
•
Communication fail:
•
Lamp fail:
•
Electronic fail:
•
ok - Lamp on:
•
ok - Lamp off:
Mode:
configure the operating mode of the ELC luminaire.
•
Maintained:
•
Not
maintained: configure the luminaire as not maintained.
•
Switchable:
luminaire's lum input status)
#ID ModBus:
number in which the luminaire is zoned and the second digit (from 1 to 32) is the
identifier of the luminaire within the circuit.
30
LPS24 – USER MANUAL
OK Main menu
Installed:
In failure:
> Filter:
>Circuit:
>Serial Number:
Status:
* Mode:
#ID ModBus:
#Start zoning:
Circuits
summary of the ELC series luminaires registered on the device.
summary of ELC series luminaires registered on the device that have a fault.
select (with < and >) the number of circuits for which the luminaires will be
(not located
and 1 to 6)
select (with < and >) the various luminaires on the selected circuit.
displays the status of the ELC luminaire.
the luminaire has not communicated with the device for less
the luminaire has not communicated with the device for over 24h.
the luminaire has detected a fault in its light source.
the luminaire has detected a fault in its electronics. Requires repair
no faults and with the light source illuminated
no faults and with the light source off
configure the luminaire as maintained.
configure the luminaire as switchable (depending on the status of the
allows assigning an identifier to the luminaires. The first digit is the circuit
LPSLan
available only if the accessory is installed.
>
Outputs
LUMINAIRES
75
3
installed
280542
ok-light on
Maintained
Luminaires
installed / Ok / in failure
www.daisalux.com
OK
Luminaires
1
1.1
1
Advertisement
Table of Contents
