Table of Contents
Advertisement
Run test/ Cancel test:
option will only appear if the necessary conditions are met (no power failure, battery
charged, no output circuit fault...).
If you want the test to run:
- Automatically: set it to
(shared with the functional test) and
- Manually: set it to
display using the
!
8.2.2.3. Capacity test
Overview
Last test:
I test:
Indicates the simulated consumption with which the capacity test is performed.
Cancel/Launch test:
running. One option or another or none is displayed depending on the status of the
device
To order the capacity test, simply configure the current to the desired battery discharge
rate and from there
24
LPS24 – USER MANUAL
Allows a duration test to be run or cancelled at that time. This
Automatic:
Automatic:
Programme test
The duration test can be configured to run automatically at a specific
time and day of the week in order to mitigate the risk of battery
discharge.
If the duration test period transpires without the device having
performed the test, the corresponding alarm is generated to alert the
user.
Although it is configured to run tests automatically, a manual test can
be performed as long as the necessary conditions are met.
Note that during execution of a duration test, the system's
battery is fully discharged, so installation will not have the
required duration until at least 24 hours after completion of the
test.
OK Main menu
>
Last test:
*I test:
#Run test
Func
Indicates the date (mm/dd/yy) and result of the last capacity test performed.
It enables a capacity test to be ordered or cancelled if it is
"Run test".
Yes. You must also set the Period,
Day of the
week.
No. Duration tests can be requested manually from the
or
Run test options.
Test
OK
Mode
CAPACITY TEST
07/05/16
30.2 A
Dur
Cap
www.daisalux.com
>
Dur
4.6Ah
Test time
>
Advertisement
Table of Contents
