Table of Contents
Advertisement
Action:
action to be run by the device to activate the auxiliary input
•
-:
No action configured
•
Auxiliary switch on:
•
Aux switch on + DBR:
activates DBR for luminaires or circuits that have this behaviour.
•
DBR switch on:
DBR activation for luminaires or circuits that have this behaviour.
•
Remote mains fail:
the facility.
•
Switch on/off:
switch on (active input) or switch off (deactivated input) in the
presence of power from the load connected to the circuits configured. Only valid for
circuits configured in "not connected" or "beacons" mode.
Circuit mask:
only displayed for inputs configured with the "remote network failure" or
"on/off" action. It shows the circuits affected by the on/off of the auxiliary input.
8.2.3.4. Gateway board
If the device has the LPSLan module connected (for further information see 6.3.7) this
screen allows you to check its status and configure. If there is no LPSLan module
connected to the device, the above information will not appear and instead the text "no
gateway" will be displayed.
Overview
OK Main menu
Reset web server:
to reset the LPSLan accessory if it fails to respond
Mode:
Select the module's operating mode
• DHCP: dynamic IP, so it requires a DHCP server on the network to which the device is
connected.
• Static: static IP. Selecting this option enables configuration of the IP, mask and
gateway on the ethernet network.
IP address:
Displays the module's IP address
IP WiFi:
Displays the IP of the wireless interface on the LPSLan module. It is not
displayed if the LPSLan module does not have WiFi connectivity
WiFi network:
View or set the name of the WiFi network to which the LPSLan module
must be connected. It is not displayed if the LPSLan module does not have WiFi
connectivity
WiFi passw:
Set the password for the wireless network to which the LPSLan module
must be connected. It is not displayed if the LPSLan module does not have WiFi
connectivity
WiFi Security:
Choose the wireless security network type:
not displayed if the LPSLan module does not have WiFi connectivity
LPS24 – USER MANUAL
switches on the entire load connected to the device
switches on the entire load connected to the device and
selected circuits turned on due to a power failure in another part of
>
Config
GATEWAY BOARD
# Reset web server
*Mode:
*IP address:
IP WiFi:
*WiFi network:
WiFi passw:
WiFi Security:
System
Dry C.
AuxIn
www.daisalux.com
OK
Gatew
OK
DCHP
192.168.106.39
192.168.106.55
RedWiFiDaisa
****
WPA/WPA2
Gatew
Wifi WEP or
WPA/WPA2. It is
27
Advertisement
Table of Contents
