Auxiliary Inputs (Aux1; Remote Fault Connection To One Lps24 Device - daisalux LPS24 Series User Manual

6.3.3. Auxiliary inputs (AUX1, ..., AUX4)
The system has four auxiliary inputs configurable with different actions. The available
options are shown in the table below
!
Auxiliary
switch on
DBR switch on
Auxiliary
switch on and
DBR on
Remote mains
failure
Switch On/off

6.3.3.1 Remote fault connection to one LPS24 device

To switch on all the luminaires in case of remote network failure, the "AUX" (auxiliary
inputs) must be connected to the DR-3 "NO" (normally open) contact (three-phase power
detector). The DR-3 must be connected in serial form as shown in the image below to
monitor more than one remote fault:
14
LPS24 – USER MANUAL
Maximum line impedance < 1kΩ.
Switching on all luminaires in the system
Switching on the ELC luminaires in DBR mode that have this
functionality
Switching on all luminaires in the system and switching on DBR on
those that have this functionality
Switching on all luminaires due to power failure in another part of the
facility
Switching on (on activation of the input) or off (on deactivating the
input) the circuits associated to the auxiliary input when connected to
power. Valid for circuits configured in
mode. This configuration takes precedence over the
permanent circuit configuration.
www.daisalux.com
"not connected" or "beacons"
permanent/non-