Table of Contents
Advertisement
8.2.4. Outputs
8.2.4.1. Circuits
On the circuit screen, the functioning of each of the LPS24 unit's circuits can be
configured. Depending on the type of circuit configured, more or fewer options can be
configured, so the items shown vary depending on the option chosen.
Overview
>Circuit:
status.
Status:
•
ok:
circuit operation correct
•
shortcircuit:
•
overload:
overload. Check the load connected to the circuit and to correct it run a circuit test
(section 12.1.1)
•
Electronic fail:
•
Load change:
circuit's consumption to vary (only if the behaviour is enabled).
Output:
•
off:
no output voltage.
•
on:
output voltage according to the polarity shown on the terminals.
•
inverted:
terminals.
•
dimming:
Kind:
configuration of the circuit's operation
•
ELC:
connected to the device. Enables communication with the luminaires through the
power cables and configure them from the unit's display. In alert it provides output
voltage according to the polarity shown on the terminals and in test or emergency
reverses the polarity of the outputs.
28
LPS24 – USER MANUAL
OK Main menu
>Circuit:
Status: ok
Output:
dimming
* Kind:
I warn:
I
0.02A
*Mode:
*Delay to alert:
* P. lum fail:
#Recalibrate
*DBR:
*External dimming:
*Alert dimming:
*Emerg dimming:
*DBR min dimming:
*DBR max dimming:
Circuits
Select (with < and >) circuit number (1 to 6) to show configuration and
circuit status
short-circuit detected in the circuit's output
the circuit's consumption at some point has exceeded the alert limit for
fault in electronic circuit components. Requires repair.
possible fault in a luminaire connected to the circuit that has caused the
status of the circuit's output voltage.
output voltage with reversed polarity relative to the polarity shown on the
dimming on the output voltage.
this setting must be used if luminaires from the Daisalux ELC series are
>
Outputs
CIRCUITS
beacons
4.1A
measured:
maintained
not active
100%
100%
100%
100%
Luminaires
www.daisalux.com
OK
1
0s
yes
yes
Advertisement
Table of Contents
