Table of Contents
Advertisement
User manual
2.
Hardware installation
2.1
Hardware installation
A maximum of two IP output modules can be installed in a TDX headend.
NOTE:
Hot swapping can be used when inserting modules into or removing modules from the TDX system, i.e. there is no need to power
off the unit.
.
2.2
IP output module
•
Insert the IP output module into either slot no. 3 or slot no. 6 in the lower section of the headend unit..
2.3
Auxiliary board
Insert the Auxiliary board as per the following:
•
Use Auxiliary board in slot no. 2 if the IP output module is in slot no. 3.
•
Use Auxiliary board in slot no. 1 if the IP output module is in slot no.
2.4
SFP transceiver
Insert the SFP transceiver in the correct AUX socket relating to slot position where the IP output module is located:
•
IP output module in slot no. 6 - SFP transceiver in AUX socket 1
•
IP output module in slot no. 3 - SFP transceiver in AUX socket 2.
2.5
Installing CAM / Smart card
Two Conditional Access modules (CA) can be inserted into each IP output module. Each CA module can descramble one or more services.
The services that can be provided is dependant on the provider of the CA module and smart card..
1. Insert the smart card into the CA module.
2. Insert the CA module into the IP output module.
NOTE:
Either (or both) CA position(s) in the IP output
module can be used.
.
7
EN
Advertisement
Table of Contents
