Table of Contents
Advertisement
Basics
Labels
Installation of
module
Removal of
module
Rev. 01 - 2014 - E
891076E_492055_492056_TDX_QAM_module - User Guide - EN.indd 4
A label is placed on the output module where you can write the information
regarding the configuration of the module.
Besides the information that you write on the label, the module type and part
number are also displayed on the label.
Note
The coloured part of the label informs you of the module type.
Each type of module is allocated a unique coloured label.
On the bottom of the module you will find a label with the bar code and a se-
rial number printed on it.
You install an output module by sliding the module into a module slot in the
lower section of the headend unit and click it into place.
Note
You can use hot swapping when you insert a module into or re-
move a module from the TDX system.
You release a CI module from a slot by using the lock mechanism that is
placed to the right of the modules in the output section.
Move the lock mechanism slightly to release the module.
4
17-01-2014 11:25:47
Advertisement
Table of Contents
