Table of Contents
Advertisement
4.9
Deleting IP/Service combinations
1 Press the Delete button associated with the IP
address/Port/Service combination to remove it
from the configuration area.
2. Press OK to confirm that the correct IP/Service
combination has been selected.
3. Press the Submit button.
4. Press the Apply button if all configuration
actions are completed.
NOTE:
The service previously contained in the
deleted combination will now be
available in the TDX-pool for
reassignment.
4.10
Status information
Status information is placed at the bottom of the
Configuration window.
Status
SW-revision
TX bitrate (Min/Max)
TX bitrate (Cur/Avg)
4.11
Status LED
A status LED is located on the front of each IP output module. The LED functions as follows:
Green - Flashing
Green - Constant
Red
Red - Constant
No color
When module S/W is updated – the LED functions is as below:
Orange
Temporary off
Temporary green
Red
EN
Detected errors
The installed output module software version.
The minimum/maximum load of megabits per second (Mbits/s) on the AUX socket.
The current/average load of megabits per second (Mbits/s) on the AUX socket.
The IP module receives data.
The IP module receives valid services.
When starting the TDX system the IP module and the system controller negotiate connection speed.
Either the IP module or the system controller has not been inserted correctly.
The IP module has not been configured or the module has not been inserted correctly.
Booting
Initiation of the software update.
Each time the modules receives a valid data package. Repeated until the update is completed without errors.
Software update failed.
20
User manual
Advertisement
Table of Contents
