Configuring Ip Output - Eit - Triax TDX Pro:Idiom IP output module User Manual

4.13

Configuring IP output - EIT

A barker channel carries all EIT information (Event Information Table) for all IP services.
The EIT barker channel can output in two ways depending on how IP output is to be distributed:
•
The EIT barker channel outputs through Link 2 on the main unit if IP output is distributed through the Link sockets.
•
The EIT barker channel outputs through the AUX socket on the first IP output module in the TDX headend system if IP output is
distributed through an IP output module
.
Click to enable Barker channel – enter IP address – enter port number
1 Click the Network tab in the TDX Service Tool
Use EIT barker for IP out
EIT barker IP address
EIT barker IP port
2 Press the Submit button.
3. Press the Apply button if no other configuration actions are required.
IMPORTANT
The IP address specified for the barker channel may not be the same as any of the IP addresses used for service distribution.
EN
Select to enable the barker channel for IP output.
Specify the desired IP address for the EIT barker channel.
Specify the desired IP port number for the EIT barker channel.
Information about which unit and socket the EIT barker channel uses.
The Network window now contains a single line of information displaying the unit and socket used by the EIT
barker channel.
More thorough information in the next chapter 6 "Network window"
22
User manual