Newborn Inlay; Infant Insert - CYBEX ATON 2 Owner's Manual

Newborn Inlay

The Newborn Inlay is a specially designed EPS foam component located in the
bottom of the Infant Carrier underneath the Seat Cover. The Inlay helps to position
smaller babies properly in the Aton 2 during their first few months. We recommend
using the Newborn Inlay until your child is 5 kg (11 lb) (about 3 months old).
Removing the Newborn Inlay
At the bottom of the seat there is an opening in the seat cover. Simply lift up and
remove the Newborn Inlay from the seat. Keep it for future use.

Infant Insert

To ensure a better fit for infants, we recommend using the Aton 2 Infant Insert. The
Insert will give more stability to the head and upper torso, as well as provide a
better Harness fit for smaller babies. We recommend using the Infant Insert until
10 kg (22 lb) or until child needs more room. If the Insert pushes baby's head
forward, or compromises the fitting of the child to the seat it should be removed.
Folding the Insert
If your child's shoulders are below the first set of Harness Slots, you may fold the
lower portion of the Infant Insert UNDER your child to boost him/her up for proper
Harness fit.
Unfold the Insert when the child's shoulders are at the height of the second set
of Harness Slots.
Removing the Infant Insert
Follow the steps for Adjusting Harness Height on page 18.
WARNING!: To avoid DEATH or SERIOUS INJURY, NEVER place extra padding
under or behind the child. The Infant Insert is the only approved padding to
be used with the Aton 2.
Using the Infant Carrier
Side View
Inlay
19