Installing The Infant Carrier Without The Base; Using A Lap And Shoulder Belt - CYBEX ATON 2 Owner's Manual

Installing the Infant Carrier without the Base using a Lap and Shoulder Belt
1. Position Infant Carrier on a rear vehicle seat, with the foot
end firmly against the back of the vehicle seat.
2. Route just the lap belt portion under both Belt Guides. BUCKLE THE BELT.
3. Lift shoulder belt over handle and around Carrier. Slide
shoulder belt into the BLUE
4. LOCK your vehicle lap shoulder belt. Refer to your vehicle Owner's
Manual for how your vehicle lap and shoulder belt locks.
In many vehicles, you can switch the shoulder belt retractor into locking
mode by pulling the shoulder belt out all the way. In some vehicles the
buckle locks. Check the vehicle Owner's Manual
system locks.
To check if the vehicle belt is locked, after you install the infant carrier,
pull up firmly on the lap belt between the Belt Guides. The belt should
remain tight if the vehicle system is locked.
WARNING!: To avoid DEATH or SERIOUS INJURY, NEVER install this child
restraint using a non-locking vehicle lap shoulder belt. A locking clip
MUST BE used with a vehicle belt that DOES NOT LOCK. Call the CYBEX
Customer Care Department at 1-877-242-5676 to obtain a locking clip.
5. Push Infant Carrier firmly into vehicle seat pressing down
near the crotch strap between the child's legs
removing slack from lap belt. Repeat for shoulder belt.
6. Make sure that vehicle belt buckle and hardware
DO NOT INTERFERE with the Infant Carrier.
40
a
Shoulder Belt Guide .
to see how your
a
, while
b
1
2
4
5
a
a
b
6
3