CYBEX ATON 2 Owner's Manual page 8

WARNING! DEATH or SERIOUS INJURY can occur
• ONLY USE this child restraint REAR FACING.
• NEVER INSTALL this child restraint in vehicle
seats that face the rear or side of the vehicle.
• ALWAYS CHECK the Harness buckle to make
sure it is securely latched.
• ALWAYS KEEP your child properly secured in
the Harness. A snug strap should not allow
any slack. It lies in a relatively straight line
without sagging. It does not press on the
child's flesh or push the child's body into an
unnatural position.
• NEVER LEAVE your child UNATTENDED or
alone in the vehicle, even for one minute.
• ALWAYS have the handle LOCKED in the
upright DRIVE/CARRY position while using
this child restraint in a vehicle.
• WHEN POSSIBLE, INSTALL the Aton 2 Base
in a seating position that will allow the Load
Leg Foot to be extended into a LOCKED
position with firm contact with the vehicle
floor.
• NEVER INSTALL the Aton 2 Base in a
seating position where the Load Leg, even
in its shortest position, causes the Base
to be pushed up above the vehicle seat. If
necessary, the Base may be installed with
the Load Leg folded up underneath.
• ONLY USE a Linear Side-impact Protection
(LSP) device on the side of the child restraint
immediately adjacent to a vehicle door or
panel.
• NEVER RAISE a Linear Side-impact
Protection (LSP) device toward a passenger
or another child.
• NEVER USE this child restraint in a vehicle
seating position where it cannot be secured
tightly. A loosely installed child restraint will
NOT PROTECT your child in a crash.
5