(2)
Installing the power units to the frame
Place the wheelchair so that it will not become unstable.
While pulling the middle of the center ring "a" with your
fingers, install each power unit using both hands so that
the torque stopper axle "b" fits into the torque-receiving
component.
Push in each power unit completely. Check to ensure
that the two balls "a" on the end of the axle can be seen
completely.
Pull each power unit to ensure that it will not come off.
● The wheel may come off if not mounted correctly. Make sure the wheel cannot come off be-
fore using the wheelchair.
● Sample 1
axle hole
torque receiver
● Sample 2
axle hole
torque receiver
torque receiver
WARNING
a
axle shaft
axle shaft
b
a
10
b
75