Checking The Residual Capacity Of The Battery During Operation; Other Functions - decon E-Move MEM20 User Manual

4.3. Checking the Residual Capacity of the Battery
during Operation
During operation, you can always check the residual capacity
of the battery from the battery residual capacity indicator lamp.
(1) When the battery residual capacity becomes less than
10%, the warning lamp flashes, and a short buzzer beeps
"Pi Pi Pi Pi" 4 times.
(2) Once the battery runs out, the warning lamp turns on, and a
long buzzer beeps "Pi—" once and stops.
When you push down the mode switch (optional) and hold it for
2 seconds, both LEDs on the power switch and on the mode
4
switch (optional) start blinking to inform you remaining battery
capacity in the same manner when it was first switched on. This
press-down action for 2 seconds will not change the driving
mode.

4.4. Other Functions

(1) Auto power off function
With the power turned on, if the handrim are not moved for 5 minutes, the power turns off
automatically. To resume operation, turn the power switch off and then back on.
Auto power off time can be changed. Contact your dealership.
● When the buzzer beeps to indicate low battery residual capacity, promptly move to a safe
place, turn off power and charge the battery, or replace with a spare battery (sold separate-
ly). It is dangerous when you get into a situation where you cannot move with assist power,
such as when crossing a road.
34
WARNING
Indicator Switch
80 – 100%
60 – 80%
40 – 60%
20 – 40%
0 – 20%
(flashes at approx. 10%)