Table of Contents
Advertisement
● Attach the hook-and-loop fastener (male) at both edges of belt to entire surface.
(7)
Slide the belt and adjust the two (2) belt edges to the
vicinity of vehicle center as much as possible.
10
● The belt edges should not be near the frame or touching moving parts (as shown incorrectly
in the "NG" inset drawing).
● Make sure the belt is taut. A slack or loose belt could allow the battery bag to come off or the
belt could get caught in moving parts.
(8)
Feed the band part of battery bag through upper side
frame and fix the belt by using fitting tape (Hook-and-loop
fastener of male at both sides).
There are two (2) ways for fitting tape attaching
methods as follows; Select the method adequate to the
wheelchair you are using and attach the tape.
78
NOTICE
NOTICE
Band Part of
Battery Bag
Frame
Belt
Belt Edge
NG
Frame Belt
Belt Edge
Frame
Battery Bag
Advertisement
Table of Contents
