Table of Contents
Advertisement
GUI – Installation
1
Image 8–57
1
Start position (mask)
2
Blending width
5.
Select one of the four starting positions values with the arrow keys and confirm.
6.
Use the arrow keys or remote digits to change the value of the blend zone and confirm.
7.
Repeat this process for all other desired sides.
8.
Continue by creating the blend mask. For more info, see "Blend & Blend mask", page 100.
Do not forget to disable the Show lines button after you achieved the desired blend zone.
8.11.2 Blend & Blend mask
About masking and blending width or height
Offset is used to clip the image on one or multiple sides (masking). This is used to hide parts of the picture that
should not be shown on the screen. For example: if the source is a Windows PC, you can hide the menu bar
using this method.
The larger the Mask value, the more the image is masked (by black bar) at the corresponding side. E.g. Top
mask of 100 will blank the top 100 lines.
Height or width is used to create a blending zone with a smooth brightness drop off. This is used to
compensate for the double brightness in overlap areas. The value is the size of the blended area in pixels.
How to set up basic blend zones?
1.
In the main menu, select Installation → Blend and Mask → Blend mask.
100
R5911443 /03
UDM
2
Advertisement
Table of Contents
