Installation Of The Mote 320 Wireless Actuator - oventrop R-Tronic RT B Operating Instructions Manual

R-Tronic with mote 320
7.5

Installation of the mote 320 wireless actuator

CAUTION
Risk of scalding on a hot radiator
During the installation process, hot water may flow through the radia-
tor as the radiator valve is open.
f If necessary, wear safety gloves during installation.
The mote 320 wireless actuator fits integrated valve sets and thermo-
static valves with connection thread M 30 x 1.5. Oventrop offers an
adapter set (item no.: 1011445) for the connection thread M 30 x 1.
The mote 320 wireless actuator with squeeze connection fits without
adapter to integrated distributors as well as RA valves and VHS
fittings of the company Danfoss.
1. Remove the casing cover of the wireless actuator. To do this, press in
the two release tabs and pull off the cover at the same time.
2. Insert two AA 1,5 V Mignon batteries into the battery case. The markings
+/- indicate the position of the batteries to be inserted.
3. Remove the mounted radiator thermostat by unscrewing it from the
valve (this can be done without draining off the heating water).
4. Screw the mote 320 wireless actuator onto the radiator valve without
casing cover. Tighten the collar nut with slight pressure.
Please note that the mote 320 wireless actuator opens and closes
the radiator valve via a mobile stem.
On delivery, the stem is in retracted position so that the wireless
actuator can be fitted more easily.
If the stem is in extended position, for example because the wire-
less actuator has been fitted to a radiator before, press the teach in/
calibration button for at least 2 seconds. This way, you may restore
the installation position of the wireless actuator at any time (stem in
retracted position). After this "calibration run" the info LED flashes
green quickly five times.
115068283#EN-V01.05.2020
Installation
21