Table of Contents
Advertisement
Transport and storage
Sensor types
0..10 V
KP10
Ni1000 (DIN)
Ni1000 (L&G)
PT1000
4.
Transport and storage
Temperature range
Relative air humidity
Particles
Mechanical influ-
ences
Weather influences
Chemical influences
10
0..100 %
-50..+150 °C
-50..+150 °C
-50..+150 °C
-50..+150 °C
0 °C - +50 °C
max. 85%
Store dry and free from dust
Protected from mechanical
agitation
Do not store outdoors
Protect from direct sunlight
Do not store together with
aggressive fluids
5.
Installation
On delivery, the actuator is in the mounting
position.
In the mounting position, the stem is fully
retracted and the DIP switches (Bit 1 bis 6) are
set to "OFF" (see section 5.3.1 on page 12).
5.1
Fitting of the actuator
Make sure that there is enough space for the
installation of the actuator.
The actuator must only be connected to the
power supply after installation!
CAUTION
Risk of burns due to hot components
An unprotected contact with hot components
may lead to burns.
f Before starting work, let the valve cool
down.
f Wear safety gloves.
1. Fit the adapter set to your valve according to the
enclosed installation instructions.
2. Fit the actuator to the connection thread of the
valve.
3. Hand tighten the collar nut.
Avoid cross threading.
NOTICE
Damage to the actuator when tightening
the collar nut with excessive torque
The actuator can be damaged and its
be function impaired if the collar nut is
over-tightened.
f Hand tighten the collar nut.
„Aktor M ST L Modbus"
101274584-V01.11.2019
Advertisement
Table of Contents
