Individual Profiles; Functions; Boost - oventrop R-Tronic RT B Operating Instructions Manual

Operation
9.2.4

Individual profiles

Individual profiles can be defined by you. To select an individual profile,
proceed as follows:
1. Go to the MAIN MENU (see section 8.1 on page 22).
2. Select the menu option TIME PROFILE.
3. Select the menu option PROGRAMME SELECTION.
4. Select the menu option INDIVIDUAL PROFILE
To create an individual profile, proceed as follows:
1. Go to the MAIN MENU (see section 8.1 on page 22).
2. Select the menu option TIME PROFILE.
3. Select the menu option PROGRAMMING.
4. Select the menu option INDIVIDUAL PROFILE.
5. Set the desired day, time and temperature. Three heating and setback
periods per day are possible.
9.3

Functions

9.3.1

Boost

With the boost mode you can heat up your radiator to maximum for a short
time. A short-term maximum heating up of the radiator can be useful in order
to quickly create a pleasant feeling of warmth through the radiant heat of the
radiator. The R-Tronic wireless thermostat fully opens the radiator valves for
a variably adjustable period (min. 5 to max. 30 minutes in steps of 5 minutes)
via all taught in mote 320 wireless actuators.
1. Go to the MAIN MENU (see section 8.1 on page 22).
2. Select the menu option FUNCTIONS.
3. Select the menu option BOOST.
4. Set the duration of the boost mode.
5. Confirm your entry with ACTIVATE.
f The boost mode is activated.
Note that the message BOOST ACTIVE only appears after the next
transmission interval between the R-Tronic wireless thermostat and
the mote 320 wireless actuator (max. 150 seconds). Until then the
text line of the display temporarily shows BOOST PENDING.
If you want to cancel the activated boost mode, e.g. because you have en-
tered too long a boost period, press and hold the back button for 3 seconds.
The current boost programming is now deactivated. At the end of the rapid
28
R-Tronic with mote 320
115068283#EN-V01.05.2020