Teaching In Of Further Mote 320 Wireless Actuators; Calibration Run; Teaching In Of A Window Contact - oventrop R-Tronic RT B Operating Instructions Manual

R-Tronic with mote 320
f The radio connection between the R-Tronic and the wireless actuator is
established.
8.2.2

Teaching in of further mote 320 wireless actuators

After having taught in the first mote 320 wireless actuator successfully, the
message SUCCESSFUL is displayed for a few seconds.
After that the message TEACH IN appears again. If you confirm this message
by pressing the menu button, you have to option to teach in further wireless
actuators. Proceed as described in section 8.2.1 on page 22 to teach in
further wireless actuators.
8.2.3

Calibration run

As the "Valve OPEN/Valve CLOSED" position of the radiator valves can
always vary slightly, the mote 320 wireless actuator must determine the
individual position of of your radiator. This automatic procedure is called
"calibration run". This calibration run takes place automatically after the
wireless actuator has been taught in.
If you wish to carry out an additional calibration run, please refer to the sepa-
rate operating instructions for the wireless actuator.
8.2.4

Teaching in of a window contact

The R-Tronic wireless thermostat has to be mains operated if you
want to use a window contact.
Depending on the lighting conditions in the room, the window con-
tact may need 2 to 3 days to build up a basic charge.
As soon as a window is open, a signal from the window contact is trans-
mitted to the R-Tronic wireless thermostat giving the command to close
all taught in mote 320 wireless actuators (in the room). This is done with a
time delay. The wireless actuators continue control operation as soon as all
windows are closed again.
To teach in the window contact, proceed as follows:
1. Go to the MAIN MENU (see section 8.1 on page 22).
2. Select the menu option SETTINGS.
3. Select the menu option INSTALLATION.
4. Select the menu option TEACH IN.
5. Press the menu button to start the teach in process. The display shows
a running countdown of 30 seconds.
6. During this period, press the teach in button of the window contact
115068283#EN-V01.05.2020
Commissioning
23