Scr/Diode Module D1 Units - Danfoss VLT Series Service Manual

6.12 SCR/Diode Module D1 Units

1. Remove capacitor bank per instruction.
2. Remove input terminal mounting plate per
instructions.
3. Remove retaining screw (T25) from terminal 1 of
each SCR/Diode module.
4. Remove 8mm retaining nut from bus bar holding
bracket and remove bus bar.
CONTINUED ON NEXT PAGE
Bus bar BB2
(Step 4)
Retaining screw access
(Step 3)
Retaining nut
(Step 4)
Bus bar BB1
Figure 6-11. D1 SCR/Diode Module (1 of 3)
SCR/Diode module
VLT is a registered Danfoss trademark
6-15