Graco Informer G3000 Instructions Manual page 26

Setup Screens
Setup Screen Screen 2 2 2
Setup Setup Screen
Use this screen to set your flow rate maximum and
minimum values and to select units for flow rate.
Figure 7 Setup Screen 2
Enter the screen to set or change
preferences.
Press to activate a field for editing or to
accept the highlighted selection on a
dropdown menu.
Move to the right when editing number
fields. Press again to accept the entry
when all digits are correct.
Set your desired flow rate maximum
(first data field) and minimum (second
data field) threshold values. See Setup
Screen 3 to set or disable the flow rate
alarms.
Flow Rate Units - Select from the
following drop down options.
Cubic centimeters per minute
Liters per minute
Gallons per minute
Exit data editing.
Move between Setup Screens, fields on
a screen, or to increment/decrement the
digits when editing number fields.
26
Key
Key Key
Setup Screen Screen 3 3 3
Setup Setup Screen
Use this screen to set your alarm preferences. Select
to enable the alarm, or leave the box empty to
disable the alarm.
Figure 8 Setup Screen 3
Enter the screen to set or change
preferences.
Press to toggle between
Maintenance Totalizer Alarm Enable
Flow Rate Alarm Enable
Alarm Auto Clear Enable. If enabled,
when the flow rate returns to within the
flow limit set points, the flow rate alarm
will clear on any attached accessories,
such as a the light tower. The alarm will
still be displayed on the Informer screen.
Set display backlight timer. Enter "00" to
set the backlight to remain on.
Exit data editing.
Move between Setup Screens, fields on
a screen, or to increment/decrement the
digits when editing number fields.
Key
Key Key
and blank.
3A2040H