Non-Hazardous Locations - Graco Informer G3000 Instructions Manual

Non - - - Hazardous Hazardous Locations
Non Non Hazardous
NOTE: Non-IS Informer modules are shipped with a
NOTE: NOTE:
120 VAC power cord (E). Users in areas with another
standard voltage must provide a power supply
cord with an IEC 320–C13 female connector. See
Technical Data, page 41, for power requirements..
• The nonintrinsically safe terminals (power rail)
must not be connected to any device which uses
Key: Key: Key:
A A A
Flow Meter, 1/4 npt female inlet/outlet
B B B Informer Module
C C C
Power Supply and Cable (6 ft., 2 m), to terminal 3. See
D D D
Meter Cable (50 ft., 15 m), to terminal 4. See
E E E Power Cord (10 ft., 3 m). See NOTE above.
M M M
Ground wire and clamp. PN 244524 is included with kits to ground the Informer Module. PN 238909
is sold separately to ground the meter.
3A2040H
Locations
Locations
or generates more than 250 vrms or d.c. unless it
has been determined that the voltage has been
adequately isolated.
Cable Connections, page
Cable Connections, page
Installation
12.
12.
9