Electrical Connections - Graco Informer G3000 Instructions Manual

Electrical Connections

Connections
Electrical Electrical Connections
Install per Graco Control Drawing 16M169, in Manual
332013. See also Figure 1.
1. Connect main power supply cord (E, not
supplied) through strain relief to terminals L and
N on the power supply unit.
Note: Use either strain relief (5) or (6), depending
Note: Note:
on the size of the cord.
2. Connect power cord ground wire to ground
terminal block.
3. Connect IS power cable (F) per the following
table.
Figure 1
KEY
KEY KEY
E Inbound AC Power Cord
F Power Cable to Informer
W
Ground Wires
X Barrier
Y Ground Block
5
Strain Relief Fitting
6 Strain Relief Fitting
3A2040H
Power Power Cable Power Cable Leads Cable Leads Leads
Brown (power)
Blue (common)
Glossy Black (ground) and Black (drain) connect to
ground block.
Installation
Barrier Connection Barrier Barrier Connection Connection
Connector 1
Connector 2
13