Working Parts; Hydraulic Assembly - SaMASZ TWIST 600 Instruction Manual

Fig. 4. Location of centre of gravity and moving machine for transport
To reduce a space occupied during transportation on a TIR vehicle, the comb-side delivery
rake TWIST 600 can be transported in a flat position (Fig. 5) having put wooden blocks D under its
frame.

4.5. Working parts

Before operating the rake check condition of both the rotor and raking tines.
Worn or damaged tines should be replaced immediately with new ones.

4.6. Hydraulic assembly

Caution! Hydraulic assembly is under high pressure! Hydraulic oil under pressure may
penetrate skin and cause serious injury or death. Skin and eyes should be protected when
working around this assembly. In case of injury caused by a liquid under pressure, call a doctor
immediately.
Hydraulic hoses can be connected to the tractor's hydraulics provided that both the tractor's and
the rake's hydraulic assemblies are not under pressure. To remove the pressure from the hoses,
start the tractor's hydraulic valves several times with the tractor off.
While detaching the machine from the tractor, set the equipment aggregated aside, decompress
the hydraulic assembly and turn the tractor's engine off.
When looking for oil leaks, do so safely. Use a cardboard card. Do not touch any potential leaks
until the entire hydraulic assembly has been relieved of pressure.
Note! Use only hydraulic oil featuring oil purity class 9 - 10 in accordance with NAS 1638.
Operator's Manual
D
Rake's position for transport on a vehicle
Fig. 5.
- 8 -
Comb Side-Delivery Rake TWIST 600
D