Table of Contents
Advertisement
Taper speed
It sets the speed of the fiber attraction.
Taper Length
It sets the time of attraction.
It refers to the sum of the initially
measured splice loss value and increased
loss value. When splicing special types of
the fiber or different kinds of the fiber, a
higher splice loss can occur even under an
Offset
optimized arc discharge condition. The
minimum value of the actual splice loss
has to be set in order to accord the actual
splice loss value with estimated splice loss
value.
6.1.5 Select
Click "Select", then the selected splice mode is stored in the memory for operation.
6.1.6 Close
Click "Close" to go to the previous menu.
Non
Editable
Editable
63
Advertisement
Table of Contents
