Table of Contents
Advertisement
3.2.6.2 Operation Procedure (Heating Sleeve)
[Sleeve Procedure]
i.
As shown in the picture below, apply power to the control panel and open
the cover of the heater to prepare.
<Monitor>
ii.
Set the sleeve tube to the area of arc-fused fiber that needs to be
reinforced and place the fiber inside the heater. The connector type should
be set to the right-most position so that sleeve tube moves the heater as
closely as possible.
iii.
Activate the heater after placing the fiber. Cooling fan is run to cool the
tube 20 seconds after heater activation.
<Control Panel>
<Heating Sleeve>
Sleeve Tube
Connector
26
Advertisement
Table of Contents
