Table of Contents
Advertisement
ii. Place fiber into the holder as shown below pictures. The minimum stripping
length should be longer than 18mm.
iii. Mount the holder containing the fiber onto the slider and close slide cover.
iv. Once the thermal stripper cover is closed, the fiber is heated up for a pre-
defined time and the coating is stripped by moving the slider.
v. When stripping is completed, open the slide cover and detach the holder
containing the stripped fiber. The slider part moves to the initial position
as thermal stripper cover is opened.
vi. Remove any remaining coating residue from thermal stripper and blade
areas using a soft brush for next operation.
Be careful in handling blade part which is very sensitive.
<12 type>
<12 type>
<12 type>
19
Advertisement
Table of Contents
