Table of Contents
Advertisement
5.2.2 Blade replacement and blade mode (Rotating / Locking)
Blade change
If the cleaver does not properly cleave the fiber, rotate the blade as follow the
instructions. On the blade gear, the channel (cleaving position) from 1 to 24 is
marked. When it does not cleave the fiber properly, clean the surface of rubber pad
with the alcohol-soaked cotton swab. (But when clean the rubber pad, do not use
acetone or solvent.) And if cleaver still does not cleave properly, it means the blade
is fully used, operators are required to change the cleaving position by the following
order.
[Blade Replacement]
i. In order to replace blade, disassemble chip collector assembly and rear
pusher. Open the cover as shown picture and press the pusher pin to move
slider to forward.
Rear Pusher
Pusher Pin
44
Advertisement
Table of Contents
