Error Messages In Hp-Gl Emulation Mode - GRAPHTEC FC8600-60 Service Manual

8.4.3

Error Messages in HP-GL Emulation Mode

If any of the following command errors occur, they are nearly always caused by one of the reasons below:
(1) The software configuration regarding the output device has been changed.
(2) The plotter's interface conditions have been changed.
When a command error occurs in HP-GL
points below:
(1) Configure the software to drive your plotter, and ensure that the software's interface conditions are
correctly set.
(2) Ensure that the plotter's interface conditions are set to match those of the software.
Error
Error Display
code
E03001
E03002
E03003
E03005
FC8600-UM-251-9370
emulation mode, therefore, first check the two corresponding
TM
Cause
An unrecognizable (1) Did the plotter
instruction was
executed.
Execute a
(2) Is there any
recognizable
command.
(3) Has the correct
A command was Execute the
executed with the command with the
wrong number of correct number of
parameters. parameters.
A command Execute the
containing an command with
unusable parameter its parameters
was specified. specified within their
permissible ranges.
An unrecognizable Specify a
character set was recognizable
specified. character set.
8-7
8 TROUBLESHOOTING
Verification item
No .....Verify item (2)
receive an Yes ....Send correct data
unrecognizable
command?
No .....Verify item (3)
noise on the Yes ....Check the
line?
No .....Set the correct
model name model name.
been set for the Configure your software
plotter? application menu to
permit Graphtec plotter
control. Re-specify the
software application's
interface conditions.
Configure your software
application menu to
permit Graphtec plotter
control. Re-specify the
software application's
interface conditions.
Set the correct model
name if it was incorrect.
Solution
to plotter.
interface cable
or move the
plotter to another
location.